Metallic device that has the purpose of fixing, electrical or mechanical protection, repair, separation, vibration damping, etc. Of the conductors or cables of guard and the cables temper. Avoid damaging conductors in service condition. Protection against corrosion.
Fix suspension insulators in deflection structures with angles from 90˚ to 180.
Fix B Frames, SPA Supports, and V Angle Supports, in distribution lines and networks.
Fix B Frames, SPA Supports, P Pins and V Angle Supports, in distribution lines and networks.
It fastens the spreaders to poles in distribution networks, Made with 15.88 mm steel round with rounded tips.
Used to hold CV1 supports, T3 platforms and HT48C grates (two-post transformer rack) Made of 19.05 mm round steel with rounded tips.
The function of this fitting is to finish off the central phase in overhead distribution network lines.
C4T and C4V type cross-braces are used to support medium voltage insulators and conductors in distribution structures.
Insulation finish in networks and overhead lines.
It is used to place reel-type insulators in overhead networks. Made with 2.78 mm steel sheet (12 gauge) in the stirrup and base.
PV75, PV200, PV250, PT200 and PT250: Supports conductors and equipment in medium voltage overhead lines. PR200 and RV200: Finishing of conductors in overhead medium voltage lines.
They are used to hold the Anchor Bolt under the ground in the installation of the retainers.
DR bolts are used to assemble double-ended structures in distribution lines.
It is used as a support for the CS type bracket in underground distribution
We use this bolt to anchor the retaining of distribution structures. distribución.
Distribute mechanical forces in PT-200, PR-200, PT-250 and PV-75 spreaders.
This bracket together with the H-type clamps holds the transformers to the pole as well as fixes tie rods in medium voltage power lines and equipment.
Support of pole type insulators in medium voltage overhead lines (13kV to 33 kV).
The use of this product is to support spreaders in a flown structure.
This tie rod is used to reinforce flown structures on medium and high voltage lines.
Together with the CS slide and bolt it does not help to support cables in manholes, shafts and underground distribution vaults.
Hardware kit designed for the safe installation of lightning arresters in electrical distribution networks.
Metal structure designed for mounting distribution transformers in a two-pole configuration.
Metal platform designed for the installation of T3 type transformers in electrical distribution structures.
Crossarm designed to anchor the central conductor on H-type structures in distribution lines.
Crossarm designed to secure the central conductor on special structures in electrical distribution networks.
Eye bolt used to secure insulation components on overhead electrical network structures.
Component used to secure suspension chains and shield wire dead-ends on H-type structures in distribution lines.
Hardware designed for mounting a meter cabinet on utility poles.
Hardware element used to secure service drop cables on concrete utility poles.
Hardware component used for anchoring structures in transmission and high-voltage lines.
Support designed for heavy-duty wooden crossarms.
Hardware designed for terminating conductors on anchor structures.